Alteon L4 Switch 초기화

>> Main# boot

>> Boot Options# conf

Currently set to use factory default config block on next boot.

Specify new block to use ["active"/"backup"/"factory"]:  factory

Config block unchanged.

>> Boot Options# reset

WARNING: There are unsaved configuration changes.

Confirm operation without saving changes (leave them pending) [y/n]: y

Reset will use software "image2" and the factory default config block.

>> Note that this will RESTART the Spanning Tree,

>> which will likely cause an interruption in network service.

Confirm reset [y/n]: y

Resetting at 13:40:56 Tue Feb 24, 2015...

**** System Reset from boot cli ****

Booting .......................................

Found Image 2, Length = 3905920

Check CRC Over Image 2

Image 2 CRC OK

Memory profile is Default

Symantec feature is globally Disabled

Nortel Application Switch 2424

Rebooted because of reset from console.

Booting complete 13:41:56 Tue Feb 24, 2015:

  Version 25.0.1 from FLASH image2, factory default config block.